Publicité
Les langues disponibles
Les langues disponibles
Operation
NOTE
The appliance must come to a stop when
it moves into the base station. If the ap-
pliance does not touch the contacts when
it moves into the base station, it moves
further along the boundary cable. If the
appliance moves through the base sta-
tion, the calibration procedure has failed.
In this case, the base station must be
better aligned and the calibration proced-
ure repeated.
After the calibration movement
The pre-set current mowing duration is displayed.
For all further settings, refer to see chapter 7
"Settings", page 47.
6 OPERATION
6.1
Starting the appliance manually
1.
Switch on the appliance.
For unscheduled edge mowing: see chapter
7.7 "Edge mowing with a manual start",
page 49.
2.
Start the appliance manually.
6.2
Cancelling mowing
■
Press the button on the base station
(09/4) or on the appliance.
The appliance moves automatically into the
base station. It deletes the mowing plan of
the current day and starts again the next day
for the set time.
■
Press the button on the appliance.
The mowing is interrupted for half an hour.
■
Press the button on the appliance.
The appliance is switched off.
NOTE
In dangerous situations, the appliance
can be stopped with the STOP but-
ton (09/2).
6.3
Mowing the secondary area (01/NF)
1. Lift the appliance and place in the secondary
area by hand.
2.
Switch on the appliance.
3.
Call up the main menu.
4.
*"Settings"
5.
*"Sub zone mowing"
457296_a
6. Select the mowing time with
7.
Start the appliance manually.
Depending on the setting: The appliance mows
for the set time period and then switches off or
mows until the rechargeable battery is flat.
After mowing the secondary area, place the ap-
pliance in the base station again by hand.
7 SETTINGS
7.1
Calling up the setting – General
1.
Call up the main menu.
Note: The asterisk * in front of the menu item
indicates that it has just been selected.
2.
*"Settings"
3.
Select the required menu item.
4. Make the settings.
Note: The menu items are described in the
following sections.
5.
Return to the main menu.
NOTE
Further menu items: see chapter 5.2
"Making the basic settings", page 46.
7.2
Setting the cutting height
The cutting height can be adjusted to between
3 – 6 cm with a step width of 1 mm.
1.
*"Cutting Height"
■
*"Cutting Height XXmm": Se-
lect the required cutting height.
■
Press
The blade plate sets itself to the selected cutting
height first and the blades only begin to turn
when the appliance begins to mow.
7.3
Activating/deactivating the button tones
1.
*"Key clicks"
2. Activating/deactivating the button tones:
■
"Activate"
Activate the button tones.
■
"Deactivate"
Deactivate the button tones.
.
"Confirm".
:
:
47
Publicité
