Télécharger Imprimer la page

Ego Power+ ST1500-FC Guide D'utilisation page 7

Publicité

Les langues disponibles

Les langues disponibles

Check Damaged Parts - Before further use of the trimmer, a guard or other
part that is damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting, and any other condition
that may affect its operation. A guard or other part that is damaged should be
properly repaired or replaced by an authorized service center unless indicated
elsewhere in this manual.
Clear the area to be cut before each use. Remove all objects such as rocks, broken
glass, nails, wire, or string that can be thrown or become entangled in the cutting
attachment. Make sure that other persons and pets are at least 100 ft. (30.5m) away.
Always hold the trimmer firmly, with both hands on the handles, while
operating. Wrap your fingers and thumbs around the handles.
Avoid Accidentally Starting - Don't carry the trimmer with your finger on
the trigger.
Do not operate the trimmer in gaseous or explosive atmospheres. Motors
in these appliances normally spark, and the sparks might ignite fumes.
Damage to Trimmer - If you strike a foreign object with the trimmer or it
becomes entangled, stop the tool immediately, check for damage and have any
damage repaired before further operation is attempted. Do not operate with a
broken guard or spool.
If the equipment should start to vibrate abnormally, stop the motor and
check immediately for the cause. Vibration is generally a warning of trouble.
A loose head may vibrate, crack, break or come off the trimmer, which may result
in serious or fatal injury. Make sure that the cutting attachment is properly fixed
in position. If the head loosens after fixing it in position, replace it immediately.
Never use a trimmer with a loose cutting attachment.
Replace a cracked, damaged or worn-out cutting head immediately, even
if damage is limited to superficial cracks. Such attachments may shatter at
high speed and cause serious or fatal injury.
Check the cutting attachment at regular short intervals during operation,
or immediately if there is a noticeable change in cutting behavior.
When replacing the cutting line, use standard nylon cutting line with a
diameter that does not exceed 0.095 in. (2.4 mm); using heavier lines than
recommended by the manufacturer increases the load on the motor and reduces
its operating speed. This results in overheating and damage to the trimmer.
To reduce the risk of serious injury, never use wire or metal-reinforced
line or other material in place of the nylon cutting lines. Pieces of wire
could break off and be thrown at high speed toward the operator or bystanders.
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER
7

Publicité

loading

Ce manuel est également adapté pour:

St1500St1500-sSt1500-s-fc