Publicité
Les langues disponibles
Les langues disponibles
28
5.3
INSTALLING CEMENT BOARD
EN
A NON-COMBUSTIBLE FINISHING MATERIAL BORDER, SUCH AS BRICK, MARBLE, GRANITE,
ETC. IS REQUIRED. FINISHING WITH JUST CEMENT BOARD TO THE SIDES AND TOP OF THE
THE SURFACE ABOVE THE APPLIANCE GETS VERY HOT. IF PROPER FINISHING MATERIALS ARE
If only a painted surface is desired, a full single sheet of Wonder Board cement board must be used above the
door opening. We recommend the cement board to be cut and seamed as per illustrated below, when fi nishing
the entire surface with a non-combustible decorative fi nishing material.
CEMENT
BOARD
SIDE
WALL
2"
(50.8mm)
6"
(152.4mm)
MIN.
Joint Compound where required
Joint compounds such as Durabond 90 and tapes that are resilient to heat and cracking should be used when
taping and mudding seams.
Setting tiles and grouting
We recommend you use tiles with a dry butt joint to be installed using a two-part mortar with an acrylic latex
additive, such as Mapei Kerabond/Kerlastic, to allow for slight movement in the normal operation of the
appliance.
If grout is used between the tiles, a polymer-based grout, such as Mapei Ultracolour plus, is recommended.
Primer/Paint
For a painted surface, use a 100% acrylic latex primer and fi nish coat. Paints may discolour.
W415-1150 / 02.28.13
APPLIANCE IS NOT ALLOWED.
NOT USED, CRACKING CAN OCCUR.
See-Thru
COMBUSTIBLE
FINISH MATERIAL
30
(768.4mm)
36
1
/
"
2
(927.1mm)
2"(50.8mm)
6" (152.4mm)
MIN. TO A
SIDE WALL
WARNING
!
CEMENT
BOARD
15 3/4"
(400.1mm)
1
/
"
4
(927.1mm)
Peninsula
COMBUSTIBLE
FINISH MATERIAL
15 3/4"
(400.1mm)
30
(768.4mm)
36
/
"
1
2
2"(50.8mm)
6" (152.4mm)
MIN. TO A
SIDE WALL
1
/
"
4
Publicité
