Connecting To Natural Gas; Connecting To Liquefied Gas; Flexible Hose; Installing The Safety Valve - Bosch HBL6EI231 Notice D'utilisation Et De Montage

Connecting to natural gas

Only use connecting lines or flexible hoses which comply with
the applicable regulations and which are approved for this
purpose.
Screw the adapter piece (3) and the seal (2) to the gas
1.
connection (1).
Hold the adapter piece (3) with a spanner and screw it to a
2.
fixed connecting line (4) or a flexible gas connecting hose.
Only use approved sealing compound to seal the thread.

Connecting to liquefied gas

If you connect the appliance to liquefied gas, you must always
install a suitable gas pressure regulator. Use the total gas
consumption of the appliance stated on the rating plate to
select a suitable gas pressure regulator.
Only use connecting lines or flexible hoses which comply with
the applicable regulations and which are approved for this
purpose.
Screw the corrugated tube union (3) and the seal (2) to the
1.
gas connection (1).
Slide a flexible gas connecting hose (5) onto the corrugated
2.
tube union (3).
Pull the clamp (4) tight.
3.
Only use approved sealing compound to seal the thread.

Installing and dismantling the appliance

Preparing the kitchen units

The safe operation of this appliance can only be guaranteed
■
if it has been installed to a professional standard in
accordance with these installation instructions. The installer is
liable for damages incurred as a result of incorrect
installation.
Carry out all cut-out work on the kitchen unit and worktop
■
before fitting the appliances. Remove any shavings or the
function of the electrical components may be impaired.
16










Flexible hose

If you use flexible hoses, make sure that:
the hoses do not become trapped or squashed.
■
the hoses are not subject to twisting or pulling forces.
■
the hoses, for example, do not come into contact with sharp
■
edges or cutting edges.
the hoses do not come into contact with parts that could
■
reach a temperature higher than 70 °C above room
temperature.
Make sure that the full length of the hoses is accessible for
inspection.

Installing the safety valve

The installation of a safety valve for opening and closing the
gas supply is a compulsory requirement. Fit the safety valve
between the gas supply line to the appropriate room and the
appliance. Ensure unhindered access to this valve.

Checking for leaks

After connecting the gas line, check the connections for leaks
using soapy water.

Initial use

Switch the appliance on as described in the instructions for
use. Light all the burners and check that the flames remain
stable at both the high and low settings.