Mount To Cabinet; Check The Installation - Bosch HBE5451UC Manuel D'installation

Four-wire Connection
Ungrounded Neutral
Connect the red oven wire to the red electrical supply
▯
wire (hot wire).
Connect the black oven wire to the black electrical
▯
supply wire (hot wire).
Connect the white neutral oven wire to the white
▯
neutral (not bare or green ground) electrical supply
wire.
Connect the green ground oven wire to the bare or
▯
green ground electrical supply wire.
Three-wire Connection
Grounded Neutral
Connect red wire from oven to red wire in junction box.
▯
Connect black wire from oven to black wire in junction
▯
box.
Connect both green ground wire and white wire from
▯
oven to white, green or bare neutral wire in junction
box.
The conduit cable, where connected at the oven, swivels.
Rotate conduit cable upward (or downward) and direct
through hole prepared in cabinet to attach to junction
box.
To maintain serviceability, the flex conduit must not be
shortened and should be routed to permit temporary
removal of the oven.
8

Mount to cabinet

NOTICE: Before installing the appliance, be sure to
verify the cabinet dimensions and electrical connections.
Note: The appliance is heavy. It is advisable to install it
with a second person.
Fully insert the appliance and centre it.
1.
NOTICE: Do not kink the connecting cable or route it
over sharp edges.
Remove the rubber profiles.
2.
In the holes there are plastic sleeves which are
3.
required for fastening.
Secure the appliance to the cabinet using 2 screws.
4.
Reinsert the rubber profiles.
5.

Check the Installation

WARNING
9
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
Switch on the circuit breaker.
Verify that elements function properly.