Description; Accessories; Technical Data - Hilti PTA 20 Mode D'emploi

On the tool
C A U T I O N
LASER RADIATION - DO NOT
STARE INTO BEAM
620-690nm/0.95mW max.
CLASS II LASER PRODUCT
Do not stare into the beam.
en
Laser warning plates for the USA in accordance with CFR
21 § 1040 (FDA).

2 Description

2.1 Use of the product as directed
The PTA 20 is a calibration tool that can be used to
calibrate the PT 10 quick check device quickly and easily.
2.2 Features
This calibration tool allows the user to carry out the
calibration quickly and easily. The PTA 20 is robustly built
and features easy, self-explanatory operation.

3 Accessories

Designation
Mains adapter

4 Technical data

Right of technical changes reserved.
Laser class
Operating status indicators
Power supply
Operating temperature range
Storage temperature
Protection against dust and water spray
Tripod thread
Weight, approx.
Dimensions
8
On the tool
Laser Class 2 in accordance with IEC/EN 60825‑1:2007
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
2.3 PTA 20 calibration tool in Hilti toolbox - items
supplied
1 PTA 20 calibration tool
1 Mains adapter
1 Operating instructions
1 Manufacturer's certificate
Description
PTAW 80
Visible, 625...645 nm: +25°C
<1mW Class 2 in accordance with IEC 60825‑ 1:2007;
EN 60825‑1:2007 and Class II in accordance with
CFR 21 § 1040 (FDA)
LCD display
Plug-type mains adapter, DC voltage 6V: 0.2A
+10...+35°C
+0...+50°C
IP 54 (protection against dust and water spray)
BSW: ⁵⁄₈"
1 kg
160 mm X 90 mm X 70 mm