Troubleshooting; Disposal; Manufacturer's Warranty - Tools; Fcc Statement (Applicable In Us) / Ic Statement (Applicable In Canada) - Hilti PTA 20 Mode D'emploi

9 Troubleshooting

Fault
The tool can't be switched on.
The display remains blank.
No laser beam.

10 Disposal

WARNING
Improper disposal of the equipment may have serious consequences:
The burning of plastic components generates toxic fumes which may present a health hazard.
Batteries may explode if damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or
environmental pollution.
Careless disposal may permit unauthorized and improper use of the equipment. This may result in serious personal
injury, injury to third parties and pollution of the environment.
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The materials must
be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back old tools and appliances for recycling. Ask Hilti customer service or your Hilti representative for further
information.
For EC countries only
Do not dispose of electrical appliances together with household waste.
In observance of the European Directive on waste electrical and electronic equipment and its implement-
ation in accordance with national law, electrical appliances and batteries that have reached the end of
their life must be collected separately and returned to an environmentally compatible recycling facility.

11 Manufacturer's warranty - tools

Please contact your local Hilti representative if you have
questions about the warranty conditions.

12 FCC statement (applicable in US) / IC statement (applicable in Canada)

This device complies with part 15 of the FCC rules and
with CAN ICES-3 (A) / NMB-3 (A). Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference.
Possible cause
The supply cords are not (or not fully)
connected.
The tool is not connected to the elec-
tric supply.
The laser module is faulty.
(2) This device must accept any interference received, in-
cluding interference that may cause undesired operation.
NOTE
Changes or modifications not expressly approved by
Hilti may restrict the user's authorization to operate the
equipment.
Remedy
Check the supply cord and ensure
that all cords are connected correctly.
Check the supply cord and ensure
that all cords are connected correctly.
Return the PTA 20 to a Hilti service
center.
en
11