PLEASE NOTE:
The following additions to your owner's manual will enable you to achieve optimal
emissions performance from your stove. Important safety tips are also included.
‐
Proper Installation – Please refer to the Installation section of your owner's manual and
follow the guidelines listed therein for safety and for optimal emissions performance.
Additional information:
Venting:
Be sure to follow your owner's manual's recommendation for venting, including the proper types of flue
systems and pellet vent pipe.
Also note that Outside Air Connection (combustion air) is MANDATORY for proper safe operation, and to
achieve optimal emissions performance.
Observe the vent termination clearances specified in your owner's manual, and contact our Technical Support if
you have any questions. Phone (800) 245‐6489 or email service@englanderstoves.com .
Be certain that all aspects of the venting system are installed to the venting manufacturer's
instructions, particularly the required clearances to combustibles.
Your pellet stove operates on a negative draft system, which pulls combustion air through
the burn pot and pushes the exhaust air through the vent pipe and out of the building. This unit
must be installed in accordance with your owner's manual's detailed descriptions of venting
techniques; not installing the stove in accordance with the details listed can result in poor stove
performance (including poor emissions), property damage, bodily injury or death. England's Stove
Works is not responsible for any damage incurred due to a poor or unsafe installation.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
33
PELLET -
Meets the 2015 U.S. Environmental Protection Agency's
wood emission limits for wood heaters sold after May 15, 2015
EPA INFORMATION