England's Stove Works 25-PDVCH Manuel D'installation Et D'utilisation page 25

REPLACEMENT PARTS, ACCESSORIES AND OPTIONS
AC-GGK
AC-DGKC
AC-G9
AC-SHN
AC-MBSP
PU-047040
PU-BP02
PU-BP98WP
PU-076002B
PU-4C442
PU-AF6T
PU-AF11B
PU-62-40-151-3
PU-UCF204-12
PU-2X570
PU-CB19
CU-VS
PU-CBMG
PU-BPG
PU-ABGN
PU-HLG
PU-CHA
PU-CBF6
AC-HLSB
AC-HP
AC-CT
PU-OAK
AC-3000
AC-3100
AC-106-PBN
If you have any questions or problems contact the Technical Support Department:
Technical Support Department
P.O. Box 206
Monroe, VA 24574
You may also order parts and options, view frequently asked questions and more,
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
25
Glass Gasket Kit (gasket only, no glass)
Door Gasket Kit (#2 on diagram)
9" x 9" Glass with Gasket (#3 on diagram)
Nickel Door Spring Handle
Hi-Temperature Black Paint
1 RPM Auger Motor Assembly (#18 on diagram)
Burn Pot
Wear Plate (fits inside Burn Pot)
Combustion (Exhaust) Blower (includes 3" adapter)
(#'s 8 and 9 on diagram)
Convection (Room Air) Blower (#13 on diagram)
Top Auger Shaft (#14 on diagram)
Bottom Auger Shaft (#14 on diagram)
Hopper Lid Latch (2002 and later Models; for earlier models
order PU-103-50) (#25 on diagram)
Auger Bearing (#16 on diagram)
¾" Locking Collar (#17 on diagram)
Digital Control Board (#12 on diagram) - PU-CB04 if stove
Serial Number is below 150,000
Vacuum Switch (See wiring diagram pg. 19)
Combustion Blower and Motor Gasket (#10 on diagram)
Burn Pot Gasket (#6 on diagram)
Auger Bearing Gasket (#15 on diagram)
Hopper Lid Gasket (#22 on diagram)
Cartridge Heater (Igniter) Assembly (#27 on diagram)
6 AMP Control Board Fuse
Hopper Lid Safety Switch (See wiring diagram pg. 19, 09/2008
and later only)
Hinge Pin rivet for cast door (not shown)
Cleaning Tool for pellet stoves (not shown)
OPTIONS:
Outside Air Kit
3" Pellet Vent Kit (Through-the-Wall)
4" Pellet Vent Kit (For High Altitudes – 4000+ ft.)
Brushed Nickel Window Trim
service@englanderstoves.com
Parts Orders ONLY: 800-516-3636
Questions: 800-245-6489
www.HeatRedefined.com
on our web site:
(Fax: 434-929-4810)