Publicité
Les langues disponibles
Les langues disponibles
If the ice cube tray is stuck to the
freezer compartment, loosen it with
a blunt implement only (e.g. spoon
handle).
To loosen the ice cubes, twist the
2.
ice cube tray slightly or hold it
briefly under flowing water.
operation
7 Basic operation
operation
7.1 Switching on the appli-
ance
Electrically connect the appliance.
1.
→ Page 44
Note: If the appliance has been
previously switched off using the
control panel, press and hold
for ten seconds.
a The appliance begins to cool.
a A warning tone sounds, the tem-
perature display (freezer compart-
ment) flashes,
and the status display lights up red
because the freezer compartment
is still too warm.
Switch off the warning tone using
2.
.
goes out as soon as the
a
set temperature has been reached.
Set the required temperature.
3.
→ Page 47
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
lights up
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
Press and hold
▶
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
Select the refrigerator compart-
1.
ment using
Press
/
repeatedly until the
2.
temperature display (refrigerator
compartment) shows the required
temperature.
To reach the set temperature, slide
the temperature controller for the
storage container to a position that
is one third from the bottom.
→ Page 47
The recommended temperature in
the refrigerator compartment is
4 °C.
Setting the storage container
temperature
To reduce the temperature, slide
1.
the temperature controller in the
direction.
To increase the temperature, slide
2.
the temperature controller in the
direction.
→ Fig.
7
Setting the freezer compartment
temperature
Select the freezer compartment
1.
with
.
Press
/
repeatedly until the
2.
temperature display (freezer com-
partment) shows the required tem-
perature.
operation en
for ten seconds.
.
47
Publicité
