Velleman ED8A101 Notice D'emploi page 5

•
The clock and date setup exits automatically after ±60 seconds.
Alarm 1
•
Press the mode button [F] 2 times, the first alarm icon [2] starts
flashing.
•
Press the set button [G] repeatedly to select hour and minutes setting
and modify with the up [H] or down [I] button.
•
Press the mode button [F] 2 times to return to time display. The display
indicates the time icon [1] and the first alarm icon [2], indicating that the
alarm will be activated at set time.
Alarm 2
•
Press the mode button [F] 3 times, the second alarm icon [3] starts
flashing.
•
Press the set button [G] repeatedly to select hour and minutes setting
and modify with the up [H] or down [I] button.
•
Press the mode button [F] once to return to time display. The display
indicates the time icon [1] and the second alarm icon [3], indicating that
the alarm will be activated at set time.
Temperature mode
•
When in normal time display, press the set button [G] to select
between °Celsius or °Fahrenheit display.
7.
Operation
•
The clock has a noise/touch control function. When noise (e.g.
clapping hands, a knock on the table) or a touch anywhere on the
body of the clock is detected, the backlight will switch on and the
time will be projected on a wall or ceiling for ±5s.
•
To activate the noise/touch control, set the noise/touch control
switch [K] to the ON-position. When switched to the OFF-position,
only the snooze button [E] will activate the backlight and projection
system.
•
Alter the projection direction by turning the projection part [C],
maximum angle ±60°.
•
Focus the projection lens by turning the lens focus knob [D].
•
To activate/deactivate alarm 1 press the up button [H]; to
activate/deactivate alarm 2, press the down button [I].
•
When an alarm sounds the corresponding icon will flash. Press the
snooze button [E] to enable snooze mode. The snooze icon [4] is
displayed and the alarm will sound again after 4 minutes. To exit
00 (06/01/2009)
WT8097
5
®
Velleman