Velleman WT81 Serie Mode D'emploi

WT81 -- MULTIFUNCTIONAL PROJECTION CLOCK
1. Introduction
Thank you for buying the WT81 ! This multifunctional clock does much more than merely display the correct time !
This device is also equipped with several other functions : an alarm, a temperature readout, a snooze and a
projection function and a backlight.
2. Features
Display in normal mode : Month, date, day of the week, hours, minutes and temperature are displayed
Daily Alarm : Hours and minutes should be entered
Temperature Readout : Select °C or °F for the temperature display
Backlight : Enables the user to read the display in the dark
Projection : Press SNOOZE/LIGHT to project the time on the surface of your choice for three
3. Batteries (not incl.) and Adapter (incl.)
Remove the cover of the battery compartment at the back of the WT81 and insert two AA-batteries of 1.5V. Mind the
polarity when inserting the batteries.
Connect the included AC/DC adapter (220V/50Hz) with the mains to project the time permanently.
4. Setting the Correct Date and Time
Note : The digits will change faster if the UP or DOWN button is held. The day of the week is adjusted automatically.
Hold the TIME/CAL SET button for three seconds until the digits for the hours start to flash. Enter the hours with UP or
DOWN and confirm with TIME/CAL SET. The digits for the minutes start to flash. Enter the minutes with UP or DOWN
and confirm with TIME CAL/SET. The digits for the year start to flash. Select a year between 1999 and 2048 with UP or
DOWN and confirm with TIME/CAL SET. The digits for the month start to flash. Select the month with UP or DOWN
and confirm with TIME/CAL SET. The digits for the date start to flash. Enter the date with UP or DOWN and confirm
with TIME/CAL SET. The device returns to the normal display mode.
5. Setting the Daily Alarm
Press the ALM SET button once to display the current alarm time for ± 6 seconds. Hold ALM SET for three seconds to
enter the alarm-setting mode. The digits for the hours start to flash. Enter the hours with UP or DOWN and confirm with
ALM SET. The digits for the minutes start to flash. Enter the minutes with UP or DOWN and confirm with ALM SET.
The device returns to the normal display mode.
Press the ALM ON/OFF button at the back of the device. The
the alarm is armed. Press ALM ON/OFF a second time to delete the symbol from the display and disarm the alarm.
The alarm will sound for 1 minute at the programmed time, unless the user presses one of the buttons. Press a random
button to stop the alarm for 24 hours.
WT81
All manuals and user guides at all-guides.com
seconds.
symbol should now appear on the LCD to signal that
1
VELLEMAN