Télécharger Imprimer la page

Husqvarna TC 242TX Manuel D'utilisation page 33

Masquer les pouces Voir aussi pour TC 242TX:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 45
Note:
Multi-viscosity oils (5W30, 10W30, and so
on) help the engine start easily in cold weather but
causes increased oil use when used in temperatures
above 32°F/0°C. Do a check of your engine oil
level frequently to prevent possible engine damage
caused by low oil level.
Change the oil after intervals of 50 hours of
operation. If the product is not used for 50 hours
in a year, change the oil at a minimum of 1 time a
year.
Do a check of the crankcase oil level before you
start the engine and after each eight (8) hours of
operation.
Tighten the oil fill cap/dipstick each time you do a
check of the oil level.
To do a check of the engine oil level
The engine in the product is filled with engine oil for
ambient temperatures of more than 32° F (0° C). For
operation in ambient temperatures of less than 32° F
(0° C), use the correct engine oil to make the product
easier to start. Refer to .
1. Park the product in level ground.
2. Remove the oil fill cap and dipstick and clean it
with a cloth.
3. Put the dipstick into the oil fill tube. Do not turn
the oil fill cap onto the oil fill tube.
4. Remove the dipstick. Use the gauge on the
dipstick to examine the engine oil level. If
necessary, fill engine oil until the mark "FULL"
on the dipstick is reached. Do not fill too much
engine oil.
ADD
FULL
5. Put the dipstick into the oil fill tube. Make sure
that the oil fill cap is fully tightened.
Note:
To replace the engine oil, Refer to
change the engine oil on page 33 .
To change the engine oil
Note:
All oil must meet API service classification
SJ-SN.
Note:
Oil drains more freely when the engine is
warm.
Make sure the product is on a level surface
before you chain the engine oil. Set the possible
temperature range before the oil change.
Collect the oil in an applicable container.
1923 - 006 - 14.07.2023
CAUTION - DO
01341
To
1. Lift the hood.
2. Remove the fastener (A) from the lower dash
cover (B).
B
A
CAUTION:
dash cover (A) carefully to make sure
the cover tabs (C) are not broken.
3. Move the lower dash cover (B) to release the
cover tabs (C) from the tapered slots (D) in the
lower dash cover (B) and then remove.
4. Remove the oil fill cap and dipstick.
CAUTION:
let dirt enter the engine when you
change the oil.
5. Install the drain tube (E) onto the oil drain valve.
F
6. Turn the valve counterclockwise with a 10 mm
wrench to open the oil drain valve (F).
7. Turn the drain valve clockwise to close it (G)
when the oil is drained.
Note:
Use a 10 mm wrench to apply a small
quantity of torque to keep the drain valve closed.
Do not tighten too firmly.
8. Remove the drain tube (E) and keep it.
9. Fill the engine with new oil through the oil fill
dipstick tube.
Note:
Put oil into the engine slowly. Do
not fill the engine with too much oil. For the
approximate capacity, see
page 41 .
D
C
Remove the lower
Be careful not to
G
E
Technical data on
33

Publicité

loading