Husqvarna TC 242TX Manuel D'utilisation page 27

• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around
the transaxle fan and cooling fins.
• Examine the cooling fan to make sure the fan
blades are clean and not damaged.
To examine the transaxle pump fluid
• Make sure that the transaxle pump fluid does not
leak.
• Speak to the nearest approved service center or
department if the transaxle pump fluid leaks.
To adjust the front wheel toe-in and camber
The front wheel toe-in and camber is correctly set at
the factory. The front wheel toe-in and camber are
not adjustable.
• Speak to an approved service center if the
factory-set front wheel toe-in or camber is
damaged.
To replace the fuse
This product has an automotive-type fuse. The fuse
holder is located behind the dashboard.
1. Hold the fuse holder and pull the blown fuse out.
2. Put a new fuse in the fuse holder.
To remove and install the engine cover and
the grill assembly
1. Lift the engine cover.
2. Disconnect the headlight wire connector (A).
3. Stay in front of the tractor. Hold the engine cover
on its sides. Tilt the engine cover in the direction
of the engine and lift it to remove it from the
product.
4. Install in the opposite sequence.
1923 - 006 - 14.07.2023
A
To remove the movement drive belt
B A
C
D
E
F
1. Park the product on a level surface.
2. Engage the parking brake. Refer to
and disengage the parking brake on page 18 .
3. Remove the cutting deck. Refer to
and install the cutting deck on page 29 .
Note:
Be careful with the movement drive
belt and the position of the belt guides and belt
keeper.
4. Disconnect the clutch wire harness (A).
5. Remove the belt keeper (B) on the right side of
the product.
6. Remove the movement drive belt from the
stationary idler pulley (C), and the clutch idler
pulley (D).
7. Remove the movement drive belt from the center
idler pulley (E).
8. Pull the movement drive belt to the rear part
of the product. Carefully remove the movement
drive belt from the transmission input pulley and
above the cooling fan blades (F).
9. Remove the movement drive belt from the
engine pulley and around the clutch pulley (G).
10. Move the movement drive belt to the rear part of
the product and off the steering plate (H).
11. Remove the movement drive belt from the
product.
Battery
To clean the battery and the terminals
Corrosion and dirt on the battery and terminals can
cause the battery to drain power.
G
H
I
To engage
To remove
27