Husqvarna TC 242TX Manuel D'utilisation page 14

5. Push the lever (D) through the full lever shroud
and install the bolt (A).
D
6. If it is necessary to adjust the full lever, do the
steps that follow.
a) If the grass is heavy or wet, remove the bolt
and put the full lever in the fully retracted
position. Install the bolt again.
b) If the grass is light or dry, remove the bolt
and put the full lever in the fully extended
position. Install the bolt again.
To install the presence lever for the
grass catcher
1. Stop the engine and engage the parking brake.
2. Put the presence lever (A) into the slots in the
backplate.
3. Install the screw (B) and the nut (C).
To install the tow hitch
C
A
D
1. Remove the 3 screws (A) from the tow hitch (B).
14
A
B
C
A
B
2. Put the tow hitch in the slot (C) in the backplate
(D).
3. Install the 3 screws through backplate and
tighten them.
To adjust the seat
1. Lift the seat up and remove the seat adjustment
knob (A).
2. Loosen the seat adjustment knob (B).
A
3. Move the seat until it is in a position where you
can push the brake and clutch pedals down.
4. Line up the hole in the seat plate for seat
adjustment knob (A) with the hole in the seat.
5. Install and tighten the seat adjustment knob (A).
6. Tighten the seat adjustment knob (B).
To connect the battery
WARNING:
Make sure that ignition switch is in the
OFF position and that the ignition key is
removed.
The cable connections are on the plate on the right
side of the product, above the rear wheel.
B
Risk of electrical shock.
1923 - 006 - 14.07.2023