Publicité
Les langues disponibles
Les langues disponibles
6.4 If the appliance is not used for a long period of time
Disconnect the plug from the electric socket;
Remove all food and drink from the appliance and transfer into another refrigerator or freezer;
Carefully clean and dry the appliance;
Cover the appliance with a fabric sheet, which allows air to circulate but also protects it from
dust and dirt.
7. Troubleshooting
PROBLEM
Direct sunlight or near heat sources.
Insufficient cooling
Control unit is performing a defrost cycle.
power
The door is not completely closed or has been
opened too long.
The door seal is damaged or deformed.
The evaporator is covered in ice.
The electric plug is not inserted in the socket.
Not cooling
The compressor does not turn on.
Power failure
The appliance is not positioned on a flat sur-
Very noisy
face or the legs are not properly adjusted.
There is a vibration caused by loose screws or
bolts.
Too many products inside the appliance.
The compressor
The door is not closed or has been opened
does not shut off
automatically
too long.
The above cases are presented merely as examples of possible problems. In the event of any prob-
lem, immediately switch the appliance OFF and contact the dealer.
The following characteristics are normal and do not represent malfunctions:
At regular intervals, the temperature indicated on the digital control unit display increases by
4-5 degrees with respect to the set-point and then decreases: this is part of the normal cooling
cycle of any refrigerating appliance. See the detailed explanation in paragraph 5.4 (Operation);
The sound of flowing water. This sound occurs during normal use. It is the sound of the coolant
expanding inside the cooling circuit;
When there is high humidity, condensate on the internal part of the door is normal. Remove
the condensate by wiping it off with a soft cloth.
Requesting spare parts:
To request spare parts, contact the dealer and refer to the part number, as indicated
in the spare parts drawings at the end of this handbook. At the same time, provide the
model and serial number of the appliance, as indicated on the technical specs. label
(ref. Pic.1 and Pic.2 - Section 8).
- 30 -
CAUSES
SOLUTION
Move the appliance away from the heat sources.
Wait for the control unit to complete the defrost cy-
cle (max. 30 minutes).
Close the door completely; keep the door open for
shorter periods of time.
Contact the dealer.
Check that the door and the gasket seal well and
that no hot food has been put inside the appliance.
Contact the dealer.
Insert the electric plug in the socket.
Contact the dealer.
Check the power supply.
Place the appliance on a flat surface and adjust the
legs so that the appliance rests solidly on the ground.
Check that the screws and bolts have not become
loose during operation or transport.
Remove excess products.
Only open the door as long as necessary and check
that it is properly closed.
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
Publicité
