Publicité
Les langues disponibles
Les langues disponibles
Temperature setting (set point)
The temperature setting can be read by pressing the S
the temperature setting:
Press the S
button once to display the currently set temperature;
ET
Press the ▲(U
it's possible to set a value between the minimum and the maximum that can be set (+5 ÷ +18 °C);
Press the S
button once to confirm the new value. The current temperature inside the appli-
ET
ance will appear again on the display.
When running, the appliance will cool the cell until the currently set operating
temperature is reached. Once the set operating temperature is reached, the elec-
tronic control unit will turn off the cooling unit until the temperature detected by
the probe rises by about 4 degrees. When this happens, the control unit will turn
on the cooling unit to lower the temperature until it returns to the set operating
temperature. This "on-off" mechanism is perfectly normal and is common in all
refrigeration equipment such as refrigerated bars, cabinets, display cases, etc.
Please note that the temperature shown on the control unit display refers to the
air temperature (very susceptible to temperature changes due to the opening of
the door) and not to the temperature at the core of the appliance, which is much
more constant over time.
Lighting
The appliance is provided of internal LED illumination on the corners of the display. To turn on the
light press the L
IGHT
Error messages displayed on the control unit:
MESSAGE
EE1
EE2
EE3
EE4
If one or more error codes are displayed, write them down, turn off the appliance then turn it back
on after 3-4 minutes. If one or more of the codes are again displayed, contact the dealer to request
technical support and inform them of the error codes.
Food storage
The following instructions should be followed in order for the appliance to perform at its best:
Put the wine and beverages into the appliance after it has reached the desired temperature
displayed on the control unit. To avoid restricting air circulation, do not put too many products
in the upper part of the refrigerator;
Do not place hot products inside the appliance;
Avoid opening doors frequently and for extended periods of time, and wait at least 30 seconds
before re-opening the door.
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
) or ▼(D
) button to increase or decrease the set temperature, respectively:
P
OWN
button once, press it again to turn it off.
ERROR DESCRIPTION
Temperature probe fault
Defrosting probe fault
Compressor probe fault
Warning: high temperature
detected
button once. Proceed as follows to change
ET
EFFECT
Temperature is no longer being
adjusted correctly
Defrost is no longer being
managed correctly
Compressor overheating is
no longer noticed correctly
Compressor is not in optimal
operating conditions
SOLUTION
Contact the dealer
Contact the dealer
Contact the dealer
Contact the dealer
- 27 -
Publicité
