Publicité
Les langues disponibles
Les langues disponibles
In order to avoid damage to the compressor and cooling system, never tilt the
appliance more than 45° during transport and positioning.
After transport or handling, wait at least 4 hours after the appliance has been
positioned before switching it on. This will allow the compressor oil to level and
prevent it from entering the cooling circuit, causing irreversible damage to the
compressor and the evaporator.
Never place the appliance on a flammable surface (e.g. carpet, rugs, tablecloths, etc.);
Do not position the appliance near open flames, electric cookers, ovens or other sources of
heat, such as, for example, places exposed to direct sunlight. Heat can damage the surface of
the appliance and adversely affect its operation;
Position the appliance so that the sides and rear are always at least 15 cm from walls, furni-
ture and other objects, and the top has at least 30 cm of clearance. This is to ensure good air
circulation and easier access to all parts of the appliance as well as to provide the necessary
space for its operation;
The appliance must not be built into furniture or masonry walls;
Do no drill holes into the appliance or attach objects to it;
The appliance must not be used if it is out of order, damaged or has suffered impacts;
To avoid hazardous situations for the user do not use accessories or spare parts which differ
from those recommended by the manufacturer. The appliance could be damaged or prove to
be a risk for the health and life of individuals.
ATTENTION! If incorrectly positioned, the appliance is not enabled for operation.
5.3 Use
Clean the appliance before its first use (see section 6 - Cleaning and servicing);
Insert the water collection tray into the appropriate guide (see Pic.1 - Section 8);
Insert the plug into an individually interlocked protected electric socket in compliance with the
regulations;
Only put food products inside the appliance after it has reached the operating temperature set
on the control unit (see paragraph 5.4 - Operation);
Food products must only be placed inside the appliance after they have been previously refrig-
erated and have reached the storage temperature;
Food products should only be placed inside the appliance if they are packaged or closed in
suitable food-grade containers.
Each support rack has a max capacity of 18 kg; the appliance must not exceed a total load of 162 kg.
5.4 Operation
The appliance is operated by means of the main O
unit, used to set the desired operating temperature. See section 8 for more details about the control
panel. The user may carry out the following operations:
Switch on/off (see Pic.1/3 - Section 8)
Turn the main O
/O
N
appear on the display.
To shut off the appliance, turn the main O
from the socket, wait at least 10 seconds before connecting the appliance to the power line again.
- 26 -
switch to the O
FF
N
/O
(I/0) power switch and the digital control
N
FF
position: the current temperature inside the appliance will
/O
switch to the O
N
FF
position. If you disconnect the plug
FF
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
Publicité
