WAGNER WallPerfect Flexio 687 E Mode D'emploi Original page 42

GB
23. Environmental protection
The device and all accessories and packaging have to be recycled in an
environmentally friendly manner. Do not dispose of the appliance with
household waste. Support environmental protection by taking the appliance
to a local collection point or obtain information from a specialist retailer.
Leftover paint and solvents may not be emptied into drains, the sewage system
or disposed of as household rubbish. It has to be disposed of separately as
special waste. Please pay special attention to the instructions on the product
packaging.
24. Important Note regarding Product Liability!
Due to an EC ordinance in effect since 01.01.1990, the manufacturer is liable for his product
only if all parts originate from or were approved by the manufacturer and the devices
are assembled and operated correctly. The use of other accessories and spare parts can
partially or completely invalidate the liability.
25. Correction of Malfunctions
Malfunction
No coating
material emerges
from the nozzle
Coating material
drips from the
nozzle
34
Cause
•
Nozzle clogged
•
Material volume setting turned too
far to the left (-)
•
No pressure build-up in container
•
Container empty
•
Feed tube loose
•
Feed tube clogged
•
Ventilating bore (Fig.14, A) clogged
•
Coating material assembly at air
cap, nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
Flexio 687
Remedy
➞ Clean
➞ Turn to the right (+)
➞ Tighten container
➞ Refill
➞ Insert
➞ Clean
➞ Clean
➞ Clean
➞ Union nut tighten
➞ Change
➞ Change