Taurus Alpatec PLEASANT WATER PUMP Mode D'emploi page 16

Downloaded by: pd-oliana on 11-08-2022 08:24 CEST
Display will show the ambient and selected
humidity. When the ambient humidity is lower
than 20% or higher than 80%, it will show.
USE:
Extend the power cord completely before
plugging in.
Plug the appliance into the mains.
Turn the appliance on, by using the power
button (10)
The pilot light comes on. (19)
Select the desired fan speed (13)
To avoid a fierce start-up of the fan, it is
advisable to start off from the lowest speed
position and, once the fan has been switched
on, progressively increase the speed to the
desired position.
Press the humidity setting buttons (18) to
select the desired humidity. The display
indicator above will start flashing.
FAN MODE:
Select the desired fan speed (high, medium
or low) by pressing the fan speed button.
The pilot light will indicate selected speed.
HUMIDITY SETTING FUNCTION:
Press the humidity setting buttons (18) to
select the desired humidity. The display
indicator above will start flashing.
The humidiy range is 35% to 80%. And the
default level is 50%.
Press the arrows (18) to adjust the desired
humidity level. For every press the humidity
% will be adjusted by 5%.
Once you have reached the desired humidity
%, stop pressing the buttons for 3 seconds.
The light indicator above will stop flashing
and the display (14) will show the ambient
humidity again.
TIMER FUNCTION:
The appliance's operating time can be
controlled.
When the dehumidifier is off, it can be pro-
grammed to automatically turn on after the
set time.
When the dehumidifier is on, the running
time of the compressor can be programmed.
In standby mode, press the timer button (16)
to iniciate this function. The display screen
(14) will show the time that is selected. Adjust
the desired time by pressing the arrows (18)
as many times as hours needed (0,5-10h).
Every press adjusts half an hour until to
10h. From 10h to 24h every press adjusts
an hour. The time programmed or remaining
time will appear on the display (14).
Once you reach the desired time, stop
pressing the button. After 3 seconds, the set
time is confirmed.
The light indicator above will turn on.
DRAINAGE (WATER TANK): (Fig 1)
When the water tank is full, the full tank light
indicator (20) will turn on. The appliance also
emits a buzzing sound to alert the user.
When the water tank is full, the operation will
stop.
Proceed to remove the water tank. Place one
hand on each side of the depression areas to
gently remove the water tank.
Pour the water out.
Proceed to place the tank back into the
appliance to restart the dehumidifier (be
careful with the water pump filter, put it
correctly)
DRAINAGE (CONTINUOUS DRAINAGE):
(Fig 2.1)
If you do not want to empty the water tank
everytime it gets full, you can connect the
drainage pipe provided to the drainage outlet
to drain the water continuously. (6)
The low end of the water pipe must be more
than 10cm lower than the height of the water
outlet.
The end of the pipe cannot remain in water. It
is highly recommended to install it on a place
that allows the water to drain constantly.
The water pipe must be kept smooth,