en
5.
Activate!BRITA!Filter!cartridge!replace!
indicator
For maximum filter performance and anti
scale protection, the BRITA MAXTRA filter
cartridge (5d) should be replaced every
eight weeks.
The BRITA cartridge replacement indicator
(3f) on the top of the machine uses bars to
indicate when the filter cartridge (5d) should
be replaced with a new one.
To activate the BRITA filter cartridge replace
ment indicator (3f), press and hold the Start
button until all four bars appear on the dis
play and blink twice.
The blinking dot in the lower right corner
indicates that the filter cartridge replace
ment indicator (3f) is activated. All four bars
should be visible.
5.! Now place the filter cartridge holder
(5c) with the filter cartridge (5d) into the
empty water tank and fill the tank with
fresh water to the max mark.
! ! Important:
Always remove the filter cartridge hold
er (5c) with the filter cartridge (5d) be
fore running the descaling programme.
From this moment on, one bar disappears
every two weeks. When no bars are visible
after eight weeks and the arrow is blinking,
replace the filter cartridge (5d).
To remove the filter cartridge (5d), simply
pull it out by its tab.
To prepare a new filter cartridge (5d),
follow the instructions in the section titled
"Preparing and inserting BRITA MAXTRA
filter cartridge" and reset the BRITA filter
cartridge replacement indicator (3f), by
pressing and holding the Start button.
i
¡
Note:
Your TASSIMO machine is now ready for
use.
i
¡
Note:
It's a good idea to purchase a new filter
cartridge (5d) when the replacement
indicator shows only one bar. BRITA
MAXTRA filter cartridges (5d) are available
from various retailers or directly from the
Bosch Customer Service Department (see
page 186 for contact information).
25
03/2013