Fiamma F45eagle Instructions De Montage Et Mode D'emploi page 33

FIAMMASTORE
EN
Read the following instructions and warnings carefully; failure to observe these installation and usage instructions
as well as the laws for driving in the relevant country may cause severe harm or damage for which the
manufacturer declines all responsibility.
Keep the original packaging to be used in case of return.
In the event of an accident involving the vehicle and/or the product, ensure that the product has not been
damaged. In the event of damage, contact your local retailer before moving the vehicle.
Fiamma declines every responsibility for any modification of the product that may cause damage and/or injury
to things and people.
Before installation, ensure compatibility with the vehicle on which the product must be installed. Checking that
the wall/roof is sufficiently solid and suitable for guaranteeing the resistance of the anchoring points is always
mandatory. If not, grip and compliance with the maximum load indicated in the instructions are not guaranteed
and it will be necessary to reinforce it.
Before leaving, make sure the awning is correctly closed. A damaged fabric does not allow the awning to perfectly
roll in. Never use the awning with a damaged canopy.
Periodically check the fixing status of the brackets, especially after having traveled the first Kms from the assembly
and every time before and after long journeys, making sure that they have not moved and that the tightening is
correct.
Always comply with speed limits and the Highway Code. The speed should always be suitable to traffic conditions
and towed load.
The awnings are produced with a high quality standard, but some of the characteristics of the materials (as little
imperfections on paint or linearity of aluminium profiles; little marks or light deformations of plastic parts), which
could be interpreted as defects, derive from the materials and from the specific work processes, and these
characteristics occur even though Fiamma uses advanced and innovative machine production techniques.
Apart from our strict quality controls, we also have our fabrics continuously controlled by independent institutes to
ensure that the fabric is tear resistant, they can hold the weight of water, the colours don't fade and it is resistant
against atmospheric agents.
To guarantee a perfect quality, the fabrics are waxed or laminated several times.
During this operation, single coloured pigments could move and thus create small bright spots in the material,
which are only irregularities that are technically inevitable to avoid, but do not compromise the impermeability of
the fabric.
MAINTENANCE INSTRUCTIONS
Make sure that your awning is completely dry and clean before closing it.
The remaining humidity could cause stains. If however you have no choice but closing the awning when it is still
wet, make sure to open it for drying within 12 hours maximum. Most of the dirt is superficial and can be removed
with clean water and a cloth or a brush. If the fabric is very dirty, add some light cleaning detergent (Marseille
soap).
Be aware never to use any aggressive chemical substances and never to clean the fabric with a high pressure
machine. We recommend not to use the awning at a temperature below 0°C.
You are advised not to wash the outer covering of the awning with an aggressive product that could alter the
surface finishes or the materials.
If the awning is more than 100 mm out of the vehicle shape, the presence of the awning must be recorded in the
vehicle's registration documents (DIN 75303 - 2019).
33