Cutting Tips; Transporting The Unit - Ryobi RY13010 Manuel D'utilisation

using your left hand, pull the starter grip and rope until
the engine runs.
 Set the start lever back to the RUN position.
NOTE: If the engine dies, set the start lever to the RUN
position and pull the starter grip and rope until the engine
starts.
 Move to the rear of the machine and squeeze throttle
lever to run.
To start a warm engine:
 Move the start lever to the START position and then
immediately back to the RUN position.
NOTE: This will set the carburetor to a fast idle setting
for easier starting.
 Pull the starter grip and rope until the engine starts.
To stop the engine:
 Place the on/stop switch in the OFF ( O ) position.
OPERATION

CUTTING TIPS

See Figure 13.
 Keep a firm grip with both hands while in operation.
 If grass becomes wrapped around the string head, STOP
THE ENGINE, disconnect the spark plug wire, and remove
the grass.
 Use the tip of line to do the cutting; do not force string
head into uncut grass.
 Wire and picket fences cause extra line wear, even
breakage. Stone and brick walls, curbs, and wood may
wear line rapidly.
 Avoid trees and shrubs. Tree bark, wood moldings, siding,
and fence posts can easily be damaged by the line.

TRANSPORTING THE UNIT

 Turn on/stop switch OFF ( O ).
 Make sure engine and exhaust are cool.
 Keep unit level to prevent fuel spillage.
9 — English