Tylo Air Notice D'installation page 12

10
5. Connect the sensor cable (6) to the NTC contact on the
circuit board (position 1) (5) (see the Connection/wiring
diagram section) according to the wiring diagram (see the
Connection/wiring diagram section, page 11).
6. Connect the light cable (if relevant) (7), see Figure 8 page 9,
to the terminal (8) according to the wiring diagram Figure 11,
page 11.
7. Close the cover and tighten the screws (see Figure 7, page 9).
8. Install the sensor on the wall see. The sensor is shown here
installed with a Tylö Sensor cover (optional item number:
9600 0038). The thermistor wire may also be passed through
the wall. Seal any holes in the wall behind the sensor, see
Figure 10. The thermistor wire may be extended outside the
sauna using low voltage wire (2-lead).
Figure 9: Installing the sensor
Figure 10: Seal any holes
Unusual voltages/numbers of phases
Contact Tylö Customer Service before connecting to voltages
or numbers of phases that are not listed in the wiring diagram
Figure 11, page 11.