Publicité
Les langues disponibles
Les langues disponibles
Making the connections
Connect the AC mains lead only after all the other
connections have been made.
[PMX802M]
Compatible speaker system (sold separately)
Use this unit with a 2 channel speaker system.
(Impedance: 3 ™ - 16 ™)
• Using other speakers can damage the unit, and
sound quality will be negatively affected.
Refer to the operating instructions for the speaker
system for details.
To household mains socket
1
Connect the antenna.
Place the antenna where reception is best.
Tape
(not supplied)
Be sure to fully tighten
the nut.
4
4
2
Connect the speakers.
([PMX802M]: Speakers are sold separately.)
Main unit (rear)
To right speaker
(rear)
Be careful not to cross (short-circuit) or reverse
2 2
the polarity of the speaker wires as doing so may
damage the speakers.
1
3
Connect the AC mains lead.
Do not use an AC mains lead with other equipment.
Conserving power
The system consumes a small amount of power (
even when it is in standby mode. Disconnect the power
supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Connecting other equipment
You can connect a DVD player, Portable audio player
etc.
Note:
• Disconnect the AC mains lead before connection.
• Switch off all equipment and read the appropriate operating
instructions.
• Components and cables are sold separately.
• If you want to connect equipment other than those
described, refer to the audio dealer.
• Sound distortion can occur when you use an adaptor.
Connecting to AUDIO IN terminal
i: Copper
Main unit (rear)
j: Silver
Left speaker (rear)
Connecting to OPT IN (Optical Audio In) terminal
Main unit (rear)
17),
Optical digital audio cable (not supplied)
• The digital audio input terminal of this unit can only detect
the following linear PCM (LPCM) signals. For details, refer
to the operating instructions of the connected device.
- Sampling frequency: 32, 44.1, 48, 88.2, 96 kHz
- Number of quantisation bits: 16/24 bits
Connecting to AUX IN terminal
Main unit (rear)
• When connecting to AUX IN terminal, you can adjust the
input level etc. For details, refer to "Using the AUX IN input"
(
12).
e.g. DVD player
(not supplied)
Audio cable (not supplied)
e.g. DVD player
(not supplied)
OPTICAL OUT
e.g. Portable audio player
(not supplied)
Analogue audio cable (‰ 3.5 mm)
(not supplied)
Publicité
