Publicité
Les langues disponibles
Les langues disponibles
Energy Saving tips
Do not install the appliance near cookers, radiators or other sources of warmth. High
ambient temperatures cause longer, more frequent operation of the compressor.
Ensure sufficient air circulation and exhaust at the appliance base and at the back
wall of the appliance. Never cover air vent openings. Do not place warm foods into
the appliance. Allow warm foods to cool first. Leave door open as
Do not set temperature any colder than
on the rear of refrigerator clean usually.
Trouble shooting
Correcting Malfunctions
Spare parts:
The following spare parts can be ordered from your local Service Force Center. You
can fit these yourself without any special skill or training, e.g.:
butter/cheese compartment,
egg holders,
door racks,
fruit and vegetable drawers,
storage racks.
A malfunction may be caused by only a minor fault that you can rectify yourself using
the following instructions. Do not perform any other work on the appliance if the
following information does not provide assistance in your specific case.
Important!
Repairs to refrigerators/freezers may only be performed by competent service
engineers. Improper repairs can give rise to significant hazards for the user. If your
appliance needs repairing, please contact your specialist dealer or your local Service
Force Center.
Symptom
Appliance does not work.
Appliance cools too much.
The food is too warm.
necessary.Keep the heat emitting condenser
Possible Cause
Appliance is not switched on.
Mains plug is not plugged in or is
loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat
source.
13
short
as necessary.
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature
regulator to a warmer setting
temporarily.
Please look in the "initial Start
Up" section.
Open the door only as
as necessary.
Turn the temperature
regulation to a colder setting
temporarily.
Please look in the "installation
location" section.
short
Publicité
