Uline H-11242 Mode D'emploi page 7

NOTE: For Left-Hand L-Desk configuration,
attach pedestal files and return components
on opposite side of desktop.
1. Remove pre-attached handles (I) from the inside
of 2-drawer pedestal file (4) and return pedestal
file (15). Align holes on outside of drawer with holes
on handle. Attach using two M4 x 22 mm bolts (I).
Repeat for other drawers. (See Figure 15)
Figure 15
I
I
4
2. With a second person, carefully flip pedestal files
(4,15) upside down. Install four adjustable glides (K)
into each pedestal file. Place pedestal files upright.
(See Figure 16)
Figure 16
K
4
PAGE 7 OF 45
L-DESK ASSEMBLY
15
15
3. Install four cam lock pins (B) into back panel (7).
Install four cam locks (C) into side panel (6) and
inner side panel (8). Attach side panel and inner
side panel to back panel. (See Figure 17)
Figure 17
6
8
7
IMPORTANT! Ensure arrow is pointing toward
edge of panel before inserting into panel's
hole. Turn cam lock ¼ to the right to lock.
Cam Function
IMPORTANT! Cam lock pins (B) must be
tightened once inserted into panel. To tighten,
grasp lower part of cam lock pin and tighten
using a Phillips screwdriver.
Tightening Cam Lock Pin
B
7
C
6
B
1/4 Right Turn
for Locking
1223 IH-11242