Uline H-11242 Mode D'emploi page 2

If assembling L-Desk, skip to page 5.
NOTE: Assemble unit on a smooth, non-marring
surface to prevent scratching. Check drawers
and packaging to ensure all parts and
hardware are included.
1. Remove pre-attached handles (I) from inside of
pedestal files (4,5). Align holes on handle with holes
on outside of drawer. Attach using two M4 x 22 mm
bolts (I). Repeat for remaining drawers. (See Figure 1)
Figure 1
I
I
4
2. With a second person, carefully flip pedestal files
(4,5) upside down. Install four adjustable glides (K)
into the bottom panel of each pedestal file. Place
pedestal files upright. (See Figure 2)
Figure 2
K
4
PAGE 2 OF 45
DESK ASSEMBLY
5
5
3. Install two cam lock pins (B) into the side of the
2-drawer pedestal file (4). Repeat on the 3-drawer
pedestal file (5). (See Figure 3)
IMPORTANT! Cam lock pins
(B) must be tightened once
inserted into panel. To
tighten, grasp lower part of
cam lock pin and tighten
using a Phillips screwdriver.
Figure 3
4
4. Install four cam locks (C) into holes on laminate
modesty panel (2). Insert two dowels (D) into each
side edge of the laminate modesty panel.
(See Figure 4)
IMPORTANT! Ensure arrow
is pointing toward edge of
panel before inserting into
panel's hole. Turn cam lock
¼ to the right to lock.
Figure 4
C
D
Tightening Cam Lock Pin
5
B
Cam Function
1/4 Right Turn
for Locking
2
1223 IH-11242