Cole-Parmer Essentials CC-200 Serie Mode D'emploi page 3

Electrical Installation
THIS EQUIPMENT MUST BE EARTHED
Before connection, please read and
understand this instruction manual and
ensure that the line supply corresponds to
that shown on the rating plate.
Power consumption is:
Model Power
CC-200 10W
The CC-200 model is provided with a UK 3 pin
and a "Schuko" 2-pin plug for 230 V installations
and a NEMA 5-15 plug for 120 V installations
Should the cable not be suitable for connecting
to the power supply, replace with suitable
alternative.
IT IS IMPORTANT THAT THIS OPERATION
SHOULD ONLY BE UNDERTAKEN BY A
QUALIFIED ELECTRICIAN
NOTE: Refer to the equipment's rating plate to
ensure that the plug and fusing are suitable for
the voltage and wattage stated.
The wires in the power cable (230 V) are coloured
as follows:
BROWN - HOT/LIVE
BLUE - NEUTRAL
GREEN/YELLOW - EARTH
The wires in the power cable (120 V) are coloured
as follows:
BLACK - HOT/LIVE
WHITE - NEUTRAL
GREEN - EARTH
IF IN DOUBT CONSULT A QUALIFIED
ELECTRICIAN
Should the mains lead need replacement a cable
2
of 1mm of harmonised code H05W-F connected
to an IEC320 plug should be used.
The appropriate power cable should be
connected BEFORE connection to the power
supply.
Frequency Fuses
50/60Hz 2xF3.15A
General Description
The unit consists of an illuminated receiver plate
and a large LED display. The pressure of marking
a colony with a felt-tip pen registers a count by
an audible bleep and advance on a digital display.
A built in averaging facility allows multiple plates
to be counted and then the average colony count
calculated. The pressure required to register a
count can be adjusted.
A choice of light or black background is available,
and the unit is supplied complete with one
Wolffhuegel graticule, segmentation disc and
centering adapters for 50-90mm dishes. A
printer and a magnifier for counting very small
colonies are available as accessories.
Counting results can also be sent to a computer
via USB.
Safety Advice Before Use
❖ The unit should be carried using both hands.
❖ DO NOT position the product so that it is
difficult to access the ON/OFF switch.
❖ DO NOT position the product so that it is
difficult to disconnect it from the mains supply
using the mains plug.
❖ The mains outlet socket used should be
located close to the equipment and readily
identifiable and accessible to users.
❖ Never move or carry the unit when in use or
connected to the mains electricity supply.
❖ In the case of mains interruption, a fault or
electrical failure, the unit will continue to
operate on removal of the fault.
Controls
Figure 1 shows the controls for the CC-200.
Figure 2 shows the back of the unit.
Figure 3 shows the underside of the unit.
1