ground in a proper way, and then fix the upright to the ground
using the chain (fig. 6).
Ensure that the supply cable is well mounted and that it does
not come into contact with the reflector of the heater or that
it does not trail into the heated area. Be sure that the heater
is not facing the ceiling or inflammable materials.
Blocking of the angle
If the blocking button is positioned with its solid part at the low side
(fig. 2-E), the appliance is locked, and the angle setting is prevented.
Vice versa if the blocking button is positioned with its solid part at the
high side (fig. 2-F) is still possible to adjust the angle of the appliance
(in this case tighten the sideward screws powerlessly).
4. USE
The SOMBRA range consists of 1200 W and 800 W heaters. The
essential element of the heater is the halogen filled quartz lamp with
a tungsten element. The heater operates at full output almost imme-
diately. The heating reaches a distance of about 2 meters in front of
the appliance.
This heating appliance does not feature a device to control
ambient temperature. Do not use it in small rooms used by
people who are unable to leave such rooms on their own
unless they are under constant surveillance.
Avoid exposing skin to the rays of the appliance for distances
less than 50 cm.
Avoid exposing eyes to the rays of the appliance for distanc-
es less than 2.70 m.
All users should be made aware of all aspects of operation
and safety and these instructions should be retained for ref-
erence..
Switch on heater and confirm that emitter is operating. Ensure that
the heater is aiming its warmth into the target area by adjusting heat-
er angles as necessary, loosening the sideward screws (fig. 2-C) and
choosing the proper slot (fig. 2-D) for fixing. Tighten the screws at
the end.
13