Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
Motor will not start.
Motor fails to start / runs sluggish.
Fuse / Circuit Breaker repeatedly
trips.
Handle feels loosely connected to
base machine.
®
American Sanders Operator's Manual (EN) - EZ Sand - HDTR
Clarke
Cause
No power.
Interlock not depressed.
Defective switch/ Bad connection
Low voltage from excessive length or
undersized extension cord.
Defective start switch.
Defective motor low voltage
Low voltage.
Bad connection.
Defective motor.
The latches have loosened up.
ENGLISH
Action
Check power supply and connection
Depress Interlock before activating control lever
Contact an authorized American Sanders Technology
Dealer.
Use a 14 Ga extension cord, not to exceed 50' length.
Contact an authorized American Sanders Technology
Dealer.
Contact an authorized American Sanders Technology
Dealer.
Eliminate extension cord.
Locate power source closer to work site. Have voltage
checked by a qualifed electrician.
Contact an authorized American Sanders Technology
Dealer.
Contact an authorized American Sanders Technology
Dealer.
To tighten latches, loosen the lock nut, screw in the latch
hook and then tighten the lock nut.
FORM NO 71358A - 9 -
EN
Publicité
