Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
EN
Operating Instructions
Follow this procedure for sanding fl oors:
1.
Move machine to work location. Decide the best
approach to sanding the desired area. When sanding the
area, work so that you are moving away from the power
supply. This will help to avoid entanglement with the
power cord and reduce the need to move the power cord
as frequently.
2. Install the sandpaper. Use the same procedure outlined
in MACHINE SETUP for installing the pad(s), to install
the sandpaper. The sandpaper uses a hook and loop
system which is identical to how the pads attach to the
drivers. Center the sandpaper over the pad and press it
against the pad until the hooks on the pad have set into
the sandpaper.
WARNING:
Injury can occur if the machine is
connected to a power source while
installing the pads or the sandpaper.
Disconnect the machine before installing
the pad/sandpaper.
3. Connect the machine to an appropriately fused and
grounded circuit.
4. While holding the handle, reach down and slide the
knurled locking collar up the handle tube and hook it to
the pin in the tube by rotating it (see fi gure 7). Lower the
handle down to a comfortable position.
5. To run the machine, push the interlock button (1), and
apply pressure to the levers (2). To stop the machine,
release the levers (2). See fi gure 8.
CAUTION:
To prevent damage to the fl ooring and to
reduce swirling, keep the machine in motion while the
motor is running.
NOTE: For sanding cuts and sandpaper, see
page 10.
-8- FORM NO 71358A
2
1
®
American Sanders Operator's Manual (EN) - EZ Sand - HDTR
Clarke
Figure 7
2
Figure 8
Publicité
