Clarke American Sanders EZ Sand - HDTR Manuel De L'utilisateur page 6

ENGLISH EN
MACHINE SET-UP
To prepare the machine for use follow this procedure:
1. Familiarize yourself with the machine. Read all danger, warning,
and caution statements and the Operator's and Parts Manual
before operating the machine. If you or the operator are unable to
read English, have this manual fully explained before attempting to
operate this machine.
2. Attach the handle to the base machine by following these
instructions:
a.) The handle label should be pointing towards the front of the
machine and the black iron casting should drop down into the
top of the base machine securely.
b.) Snap the three latches down to the base machine. The hooks
on the latches should slip over the keepers that are attached
to the base machine. The latches should require a slight push
to snap them into place (see fi gure 3).
c.) Plug the interconnect cord into the base machine (see fi gure
3A).
3. Install or replace circular pads. The pad should be replaced if
they are ripped or torn or the hook material is too worn to allow
attachment of sandpaper. To install or replace the pad(s), follow
these instructions:
a.) Lock handle in the upright position.
b.) Tilt the machine back until it fully rests on the handle.
c.) While kneeling and facing the bottom of the machine, remove
the existing pad(s) and then center new pad(s) over the grip
face (see fi gure 4).
d.) Press the pad(s) against the grip face until the hooks in the
driver have set into the pad (see fi gure 4a).
e.) Return machine to the upright position.
CAUTION: Damage to the grip face on the driver pad will occur
if the machine is operated without a pad or with a
pad that is ripped or torn. Damage to the grip face
of the pad will occur if the machine is operated
without installing sandpaper.
WARNING: Never put yourself or let others be in a position to
get injured if the machine should tip or fall while
replacing the pad or changing abrasive.
-6- FORM NO 71358A
®
American Sanders Operator's Manual (EN) - EZ Sand - HDTR
Clarke
Figure 3
Figure 3A
Figure 4
Figure 4A