Clarke American Sanders EZ Sand - HDTR Manuel De L'utilisateur page 10

ENGLISH EN
Sanding Cuts and Sandpaper
Initial Cut
The purpose of the initial cut is to remove old fi nish and gross imperfections on the fl oor surface. Use a course (20-36 grit) grain
abrasive.
Final Cuts
The purpose of a fi nishing cut is to remove the scratches produced during the initial cut. Use a fi ne (60-80 grit) grain abrasive.
If the surface remains rough after a fi nishing cut, it may be necessary to use an even fi ner grain of abrasive (80-100grit). Care should
be taken in selecting the grit size of the abrasive. A very fi ne grain will close the pores on a wood fl oor making admission of a stain
diffi cult.
If glazing or burning should occur the abrasive has dulled and must be replaced.
-10- FORM NO 71358A
®
American Sanders Operator's Manual (EN) - EZ Sand - HDTR
Clarke
revised 10/12