Publicité
Les langues disponibles
Les langues disponibles
2. Connection of Signal Cable
You can use the 3-pin XLR cable to connect the output socket of the master and the input socket of
the slave light. Connect the DIGITAL OUT socket of the master and the IN socket of the slave light,
then, connect the OUT socket to the IN socket of the next light. Ordinal to connect all the lights as
below:
IN
OUT
The connection between the output of master and input of product, it's available to use the 3 pins
XLR cable which provided by the manufacturer. Signal cable from the DMX output of the controller
to the input of the first master light, and connect to the DMX input of second slave light from the
DMX output of the first master light, analogously, till connected all the slave lights, and insert the
last connector to the output of the final light. (Notice: the diameter of core of every cable should
be 0.5mm at least, double core shelter cable should be used).The signal connecting must use the
attached 3 pins XLR cable. Notice, all the internal lead wire of the 3 pins XLR cable should not touch
to each other or connect to the connector.
A DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR
connector with a 120Ω resistor between the pin 2 and pin 3 of the XLR connector
CONTROL PANEL
Use Menu button to choose a function among MODE, SET, DMX, REST,
TEST and TEMP. Press Enter button to enter in the menu of the selected
function
Use Up and Down button to select the parameters then press Enter button
to set the selected parameter
Check the following function table :
MENU
ADDR
AUTO
MODE
SOUN
MIC
LODA
VER
SET
CALI
SSET
MOD1
DMX
MOD2
REST
ON/OFF
TEST
CXXX
TEMP
TXXX
DMX channel chart: please refer to LAST page
EN
4
IN
OUT
IN
2
VALU
A001~A XXX (AXXX)
SLAV
IP1-8
ALON /(AU-A)
MAST /AU-M)
IP1-7
ALON (SO-A)
MAST/(SO-M)
M-XX
ON/OFF
V-2.0
Code (password: 088)
CH03-CH06
OUT
3
120Ω 1W
SP_1~SP_5 (Speed)
SP_1~SP_5 (Speed)
WD
000-255
8.8.8.8.
MENU
UP
DOWN
DESCRIPTION
DMX address setting
Stand-alone mode
Internal programme (alone)
Auto-run (Master)
Sound setting (alone)
Sound setting (Master)
Mic sensitivity setting
Reload data
Software version
Input password
Calibration
Wired DMX input
18CH
10CH
Total reset
Manual channel control
Current temperature
© Copyright LOTRONIC 2021
ENTER
Publicité
