Kerbl FMC-IP1 Mode D'emploi page 62

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
o Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modi cations to this device not explicitly approved by manufacturer could void
your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device. Under Industry
Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference
to other users, the antenna type and
power
(e.i.r.p.) is not more
This device complies with Canadian CAN ICES-3(B)/NMB-3(B).
Note: The camera should be 20cm from user's body
Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux
appareils radioexempts de licence. L'exploitationestautorisée aux deux conditions
suivantes : (1) l'appareilnedoit pas produire de brouillage, et (2) l'utilisateur de
l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest
susceptible d'encompromettre le fonctionnement.
This radio transmitter (identify the device by certification number, or model number if
Category II) has been approved by Industry Canada to operate with the antenna types
listedbelow with the maximum permissible gain and required antenna impedance for
each antennatype indicated. Antenna types not included in this list, having a gain
greater than the maximumgain indicated for that type, are strictly prohibited for use
with this device.
7.0 dBi(50 ohm) dipole antenna.
1081=BA_IP_StableCam.indd 64
fi
its gain should be so chosen that the equivalent isotropically radiated
than that necessary for successful communication.
subject to the
06.11.2013 14:38:57