Kerbl FMC-IP1 Mode D'emploi page 30

Click on Search to find the WLAN signal of
your router or access point.
Select the SSID (WLAN) of your device.
Click on OK to confirm your selection.
Now select your WLAN encryption type,
enter the WLAN password (key) and click
on Apply.
The following message appears:
"Wireless setup accepted
successfully"
You can now disconnect the network cable
and operate the camera via the WLAN.
Under some circumstances, you may need
to repeat the search process for the camera
using Camera
Setup if, for example, you wanted to edit
the configuration because it was assigned
a new IP address in the WLAN.
31
1081=BA_IP_StableCam.indd 31 06.11.2013 14:36:53