Publicité
Les langues disponibles
Les langues disponibles
Installation
Anti-Tip Bracket
Use one of the methods below to secure the unit
CABINET/COUNTER ANTI-TIP INSTALLATION
(For built-in applications)
1.
Slide unit out so screws on front of unit are easily
accessible.
2.
Remove the two screws from the front of the unit.
3.
Bend bracket along one of the perforations to allow
attachment to the desired adjoining surface.
4.
Gently push unit into position. Be careful not to entangle the
electrical cord or water line, if applicable.
5.
Check to be sure the unit is level from front to back and
side to side. Make any necessary adjustments. The unit's
top surface should be approximately 1⁄8" (3 mm) below the
countertop.
6.
Secure bracket to adjoining surface.
FLOOR MOUNTED ANTI-TIP INSTALLATION
(For free-standing applications)
1.
Locate two anti-tip brackets included with the kit.
2.
Place the unit into the area where it will be installed. Check
the door, sides, and top for a proper fi t. Also test to make sure
the door opens and closes freely.
3.
Remove grille and place a mark on the fl oor at the front of the
unit. Also place a mark on the fl oor in the center of the unit.
4.
Remove the unit. Using a square, extend center line "B" (see
chart below). This line serves as the back edge for the anti-tip
brackets. From the center line, measure "A" to the left and
right. This line is the outer edge of each bracket.
Surrounding
area (Top view)
C L
Front of unit
515
A
7 5⁄8" (194 mm)
B
22" (558 mm)
5.
Place the anti-tip brackets on the fl oor against the line drawn
for the outer edge. Mark spots for the screw holes.
Surrounding
area (Top view)
Front
of
unit
C
L
6.
Use a 1/8" drill to make two starter holes and fasten the anti-
tip brackets to the fl oor using the screws provided.
7.
Place the unit back into position, making sure the feet
engage the anti-tip brackets properly. Check the alignment
of the lines made on the fl oor in step 3 with the position of
the front feet to ensure proper positioning.
6
Back of unit
Back wall
524
11 15⁄16" (303 mm)
22" (558 mm)
Drill holes and
mount anti-tip
brackets to floor
Back wall
Back
of
unit
Publicité
