Publicité
Les langues disponibles
Les langues disponibles
LED Light
Your tool is equipped with an LED light, located
on the front of the tool. This provides additional
light on the surface of the workpiece for
operation in lower-light areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running. It will
turn off approximately 10 seconds after the
variable-speed trigger switch is released.
When the tool and/or battery pack become
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
are overloaded, the LED light will rapidly flash.
Rest the tool for a while or place the tool and
battery pack separately under air flow to cool.
The LED light will flash more slowly to indicate that the battery charge is low. Recharge the
battery pack.
Installing and Removing the Saw
Blade
WARNING
pack before making any adjustments or
assembling parts.
Depress the lock-off button to the locked
position and then remove the battery pack from
the tool.
To install the saw blade:
a. Lift the tool-less blade change cover up and
insert the blade (with its teeth facing the
cutting direction) into the slot of the tool-less
blade change holder as far as it can go
(Fig. 9).
b. Release the tool-less blade change cover to lock the blade in place.
c. Pull down on the blade to verify that the blade is securely locked in place.
NOTICE: When inserting the saw blade, the back of the blade must rest in the groove of the
guide roller.
NOTICE: The tool accepts most commonly available T-shank and U-shank blades.
To remove the saw blade:
a. Lift the tool-less blade change cover up and remove the saw blade.
b. Release the tool-less blade change cover.
WARNING
after prolonged use.
Always turn the tool off
and remove the battery
Use protective gloves when removing the saw blade from the tool, or
first allow the saw blade to cool down. The saw blade may be hot
Fig. 8
Fig. 9
Tool-less Blade
Change Cover
15
Publicité
