Publicité
Les langues disponibles
Les langues disponibles
Connect the Electrical Components
Electrical current necessary:
DC Operation
12 volts DC voltage (10.4 volts min. - 15.4 volts max.)
Make no changes to any of the electrical wiring supplied with the refrigerator. Any changes that you would make to the electrical wiring
will void the warranty.
Connect the 12 volt DC supply:
To reduce the risk of electrical interference from other DC appliances and induction from voltage spikes:
- The refrigerator must have an independent filtered 12volt DC supply and not be on the same circuit as other DC appliances.
- Route the DC power supply wires including the fuses directly from the power source to the refrigerator using either Option A or Option
B shown below.
Option A
12VDC
Use a battery in parallel, in-between the refrigerator and the
Refrigerator
15A Fuse
battery charger or an electrically filtered power converter. A fuse
or circuit breaker should be wired as close to the power supply as
possible.
Option B
15A Fuse
Wire the refrigerator directly to the electrically filtered DC power
converter. The power converter must have a maximum DC ripple
voltage less than or equal to 250mV. A fuse or circuit breaker
should be wired as close to the power supply as possible.
Installation Manual 5
Publicité
