Oregon 530-120H Manuel D'instructions Original page 33

STOPPING, MAINTENANCE, DISPOSAL
520-120 / 530-120H
STOPPING AND SHUTTING DOWN
STOPPING
Turn the machine off by turning the switch to position "0" and unplug the power cable from the mains
SHUTTING DOWN
Once you have finished using the machine, disconnect it and clean it thoroughly
Store it in a dry, safe place, protected against dust and dampness
MAINTENANCE AND CLEANING
WARNING Grinder must be turned off and the power cable unplugged
from the mains before any maintenance is performed
Inspect the power cord regularly for damage Remove the plug from
the mains immediately if the cable is damaged or cut
When the grinding wheel reaches a minimum diameter of
approximately 105 mm, replace the grinding wheel
After 40 hours of use:
– Clean the lamp carefully using a rag or a cleaning brush Do not use compressed air
– Clean the grinder carefully using a rag or a cleaning brush Clean the electric
motor and the sliding guides with caution Do not use compressed air
DEMOLITION AND DISPOSAL
The machine is to be demolished by qualified personnel in compliance with current
laws in force in the country in which it is installed The symbol (on the rating nameplate)
points out that the product must not be disposed of with normal household garbage
Contact an authorized shop or your dealer for disposal instructions
Before you scrap the machine, make it unusable by cutting the power supply cable, for example, and make
the parts safe, which could cause a source of danger for children if they should play with the machine
33