Oregon 530-120H Manuel D'instructions Original page 16

PREPARING FOR USE
START-UP
Rotate the locking pin (8) counterclockwise
to block the motor unit (A)
Plug the power cable into the mains
16
CHECKING THE ASSEMBLY OF
THE GRINDING WHEEL
Stand at the side of the grinding wheel
Start the grinder by turning the
switch to position "l"
Once started, the lamp lights up to
illuminate the sharpening area
Visually make sure the grinding wheel
does not oscillate sideways or crosswise,
consequently causing abnormal vibrations
If this should be the case, stop the machine
immediately and check if the grinding wheel
has been fitted correctly If necessary, replace
the grinding wheel with another original one
Always check a freshly fitted grinding
wheel at working speed for at least one minute
before you start grinding, standing at a safe
distance to the side of the grinder, making
sure no one else approaches the machine
520-120 / 530-120H