Oregon 530-120H Manuel D'instructions Original page 32

OPERATING INSTRUCTIONS
SETTING THE DEPTH GAUGE
Put the chain in the vise jaws (16), with a
cutter up against the chain stop (12)
With the motor unit (A) pulled down, turn
the cutter adjustment knob (10) to move
the chain so that the cutter's depth gauge
is below the grinding wheel (M)
Turn the adjustment knob (11) to position the
chain stop (12) laterally to the center of the cutter
32
With the motor unit (A) pulled down, adjust the
grinding depth on the gauge by turning knob (6)
Set the depth gauge following the instructions
given in the "OPERATING INSTRUCTIONS,
SHARPENING THE CHAIN" section on
pages 28–29 For this type of sharpening
procedure, there is no difference between
the right and left cutters, therefore sharpen
all the gauges one after the other
Check if the gauge depth is correct, using
the template with the shape related to
the type of chain used Also consult the
chain table on page 12, column D
520-120 / 530-120H