Renkforce Leser 7 Notice D'emploi page 64

Example: <STX>FFLP0000E8<EOT>
<STX>FFSP0000B263<EOT>
The configuration byte is B2, i.e. binary 1011 0010
Bit 7 = „1" (on), Bit 6 = „0" (off), Bit 5 = „1" (on), Bit 4 = „1" (on)
Bit 3 = „0" (off), Bit 2 = „0" (off), Bit 1 = „1" (on), Bit 0 = „0" (off)
Index 0001: Switching time setting
The accuracy of the set time depends on the value. If seconds are used, the actual sound
time may deviate by a few seconds. Only for minutes and the half second will the set time
be precise. This is caused by the different use of internal clock or processor timers.
Bit 0 - 6 Switching time in seconds or minutes
Bit 7: Value „0": Seconds; value „1": minutes
Caution:
If the switching time is set in seconds, the value „1" is reserved for 0.5 seconds.
The value „2" means 1 second, value „3" means 2 seconds, etc.
There are no 0.5 second steps!
Example: The value „30" means 29 seconds switching time when bit 7 is set to „0".
Index 0002: Number of transponders saved
The transponder reader can save up to 500 transponder.
Index 0003: Event-Pointer
This is a pointer to the last saved event. The events are written cyclically. When the
event pointer is at its maximum, it is reset to 0 again.
The transponder reader can save up to 5000 events.
64