Electrolux ENV9MD18S Notice D'utilisation page 30

30 www.electrolux.com
Problem
The
pears and the alarm indi‐
cator is on.
The
or
the current setting appear
alternately every 5 sec‐
onds and the alarm indica‐
tor is on.
Connectivity indicator is
blinking red or white for a
long time.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
Communication problem.
symbol ap‐
Temperature sensor prob‐
or
lem.
symbol and
Connectivity issues.
Solution
Contact the nearest Au‐
thorised Service Centre.
The cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible.
Contact the nearest Au‐
thorised Service Centre.
The cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible.
Make sure your internet
connection is working
properly. If the connection
is not restored, try to
switch off and on the wire‐
less connection both on
the appliance and the Wi-
Fi access point. If the prob‐
lem persists, perform a full
reset of the appliance Wi-
Fi connection and the rein‐
stallation procedure for the
product.
If the problem persists,
contact the nearest Author‐
ised Service Centre.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.