Nakayama Pro EC1500 Mode D'emploi page 7

EN
Tighten the chain
• When the chain saw is working, the chain may be stretched. If necessary, adjust the chain tightness according to the operating specifications.
• Turn off the chain saw and cut the power supply.
• Open the knob cover, loosen the knob holder, loosen it, no need to disassemble, as shown in figure 3.
• Use a screwdriver to adjust the tension adjustment bolt to a proper position, as shown in figure 4.
1) The chain can be easily pulled along the guide plate groove.
2) Pull the chain by hand, you can see that half of the driving teeth are outside the guide plate groove.
• Turn knob tightly to complete the installation, as shown in figure 5.
Add chain oil
• Turn off the chain saw and disconnect the power supply.
• Unscrew the lid of the oil tank and add lubricating oil, as shown in figure 1.
• Tighten the lid of the oil tank and squeeze the soft lid once before use, as shown in figure 2.
Final steps before operation
• Please make sure that there are no children or other people within 15 meters (50 feet) of the work site, and ensure that there are no animals around.
• Power on: Insert the battery until the battery pack is locked and clicks. Press the power switch for 3 seconds to display the battery level. Figure 1.
• Hold the handle with your hand, press the lock button with your thumb and press the trigger with your index finger, the machine starts normally. Figure 2.
7
WWW.NIKOLAOUTOOLS.GR