Lamborghini Caloreclima MEGAPREX N 600N Instructions D'utilisation, D'installation Et De Montage page 33

MEGAPREX N 92N ÷ 600N
1. INTRODUCTION
Dear customer:
Thank you for choosing a MEGAPREX N boiler. This manual was written to provide information, warnings and advice on the proper
installation, use and maintenance of the boiler.
Please read it carefully and save it for future reference. It is in your own interest to carefully follow and observe the instructions given in this
manual, in order to fully enjoy this high-quality product.
Failure to comply with and observe the instructions contained in this manual exonerates the manufacturer from all liability, and invalidates the
warranty.
2. GENERAL WARNINGS
- The instructions manual is an integral part of the product, and provides a description of all instructions that must be observed during the
installation, use and maintenance phase.
- This appliance must only be used for the purpose for which it was expressly intended.
- This appliance is intended to heat water to below-boiling temperatures at atmospheric pressure, and must be connected to a cen-
tral heating and/or domestic hot water distribution system, in accordance with its characteristics, performance, and heat output.
- Before installation, check that the boiler has not been damaged during handling and transport.
- The installation must be performed by duly qualified personnel, in accordance with current standards.
- Before performing any cleaning or maintenance operations, unplug the appliance from the mains power supply.
- LAMBORGHINI is not liable for any damage to people or things due to errors in installation, adjustment, maintenance, or improper use.
- The boiler and corresponding system must be commissioned by authorized personnel.
- Commissioning is performed in order to verify proper operation of all adjustment and control devices.
- Qualified personnel must be contacted if the appliance is not used for an extended period.
Standards
The installer must observe current local regulations with regard to: the site chosen for the installation of the boiler, compliance with required
ventilation conditions, the tightness of the connection to the chimney, connections to fuel lines, electrical systems, and any other relevant safety
standards.
Warranty conditions
The warranty is only valid if the standards and recommendations for use contained in this manual are observed. Any non-compliance or modifi-
cation will void the warranty. The warranty does not cover damage caused by acidic condensate corrosion from the products of combustion, or
the formation of deposits caused by the use of hard or aggressive water, as these are caused solely by system operation.
3. CERTIFICATION
The CE marking certifies that the products meet the essential requirements of the applicable directives.
The declaration of conformity may be requested from the manufacturer.
PRODUCT IDENTIFICATION CODES
MEGAPREX N 92N
0QIJ3AXD Made in Spain
MEGAPREX N 107N 0QIJ4AXD Made in Spain
MEGAPREX N 152N
0QIJ6AXD Made in Spain
MEGAPREX N 190N 0QIJ7AXD Made in Spain
COUNTRIES OF DESTINATION: IT - ES - RU
4. TECHNICAL AND CONSTRUCTIONAL CHARACTERISTICS, DIMENSIONS
4.1 Description of the appliance
The construction of the boilers in the MEGAPREX N series guarantees high power and efficiency with low flue gas temperatures, thus ensuring
low polluting emissions. They are manufactured in accordance with standard EN 303, part 1. The main technical elements of the design are:
- careful design of geometries to achieve an optimum ratio between combustion volumes and heat exchange surfaces.
- the choice of materials used, to ensure long boiler life.
The boilers feature pressurized combustion with 2 flue passes, a horizontal-cylinder configuration, and flame reversal in the furnace, completely
surrounded by the water that cools it. The flame produced by the burner is reversed peripherally toward the front, where the flue gas enters the
tube bundle, featuring turbulators to create a swirling path that increases the heat exchange by convection. On leaving the tube bundle, the flue
gas enters the rear chamber and is transferred to the chimney.
The boilers are fitted with a door featuring hinges that can be reversed for opening to the right or left, and is adjustable in both height and
depth. The body is insulated with a thick layer of glass wool, and covered with a further layer of tearproof material. The external finish consists
of painted steel panels.
MEGAPREX N 240N
0QIJ8AXD Made in Spain
MEGAPREX N 300N 0QIJ9AXD Made in Spain
MEGAPREX N 350N
0QIJAAXD Made in Spain
MEGAPREX N 401N 0QIJBAXD Made in Spain
cod. 3541P191 - Rev. 00 - 03/2021
MEGAPREX N 525N
0QIJEAXD Made in Italy
MEGAPREX N 600N 0QIJFAXD Made in Italy
EN
33