BH S3TiB Manuel Du Propriétaire page 27

B: Solution: Check to see if the speed sensor is connected securely. Check to see if the sensor
is in line with the magnet on the motor and the gap between them is 3-5mm. If the problem
persists, change the speed sensor.
4. ELECTRONIC ERROR: E05
A: E05: Motor current is over limited.
B: Solution: Visually inspect the motor to see if it turns freely. Make sure that there is nothing
obstructing the movement of the running belt on rollers. If the problem persists, change the motor.
5. ELECTRONIC ERROR: E06
A. E06: Incline Motor Problem
B. Solution: Recalibrate incline motor
6. ELECTRONIC ERROR: E07
A: E07: Safety key is not detected.
B: Solution: Make sure that the safety key is installed. If problem persists, replace the safety key.
27