Publicité
Les langues disponibles
Les langues disponibles
Charging the Robotic Mower
1.
Press the I side of the power switch of the Robotic Mower and turn on the power.
► Fig.35
NOTE: It is necessary to turn on the power when charging the Robotic Mower.
2.
Dock the Robotic Mower with the charging station.
► Fig.36
NOTE: When charging starts, the LED of the Robotic Mower blinks green. When charging is complete, the LED turns off.
Initial Setting
NOTE: Peel off the protective sheet from the control part before use.
When the power of the Robotic Mower is turned on for the first time, the initial setting screen shown below appears. Enter the display language,
date and time, mowing area, and PIN code.
1.
Press the "STOP" button of the Robotic Mower and open the display cover.
► Fig.37: 1. Display cover 2. "STOP" button
2.
Select the language to use with the
► Fig.38
3.
Select the desired date and time display formats with the
4.
Select [Next] with the
/
► Fig.39
5.
Press
/
/
/
keys to select the item and enter the date and time by pressing
6.
Select [Verify] with the
► Fig.40
7.
Select the mowing area with the
► Fig.41
8.
Press
to
keys to enter PIN code.
► Fig.42
9.
Enter the PIN code again for confirmation.
► Fig.43
NOTE: Write down the PIN code and keep it in a safe place so that you do not forget it.
Checking the Wire Installation
Checking departure from the charging station
[Top menu] > [Main menu] > [Navigation preferences] > [Mower departing points]
Follow the procedure below and check that the Robotic Mower departs from the charging station. In departure operation, the Robotic Mower saves
the magnetic field strength of the charging station in its memory to enable proper docking.
NOTICE: Be sure to check departure after installing the wires. Otherwise the Robotic Mower may navigate at slow speed on the guide wire or
may not navigate at slow speed on the charging station.
NOTICE: Dock the Robotic Mower with the charging station before setting the departure method.
1.
Press the
button on the control panel.
The [Main menu] appears.
2.
Select
[Navigation preferences] on the display with the
The sub menu appears.
3.
Select [Mower departing points].
The menu select screen appears.
4.
Select the profile number of the departure method that you want to set with
► Fig.44
The option menu appears.
5.
Use the keypad and enter the desired conditions to the option format fields displayed on the screen.
Option
Wire to trace:
Departure position:
Probability
► Fig.45: 1. Maximum probability value that can be entered
/
keys, and press the
/
/
keys, and press the
/
/
/
keys, and press the
/
keys, and press the
Details
Select the type of wire that the Robotic Mower is to trace after departing from the charging station. Use
the
/
keys to display the desired wire type. To depart directly from the charging station without tracing a
specific wire, select [--------].
Enter the distance that the Robotic Mower is to move from the station before starting the mowing work. You
can enter a distance of 0 to 800 m.
Enter the probability of executing the set profile as a percentage.
key.
/
/
/
keys.
key.
to
key.
key.
/
keys, and press the
key.
/
keys, and press
28
ENGLISH
keys.
key.
Publicité
