Publicité
Les langues disponibles
Les langues disponibles
6.5 Adjustment
As the acceleration value due to gravity is not the same at every location on earth,
each display unit with connected weighing plate must be coordinated - in compliance
with the underlying physical weighing principle - to the existing acceleration due to
gravity at its place of location (only if the weighing system has not already been
adjusted to the location in the factory). This adjustment process must be carried out
for the first commissioning, after each change of location as well as in case of
fluctuating environment temperature. To receive accurate measuring values it is also
recommended to adjust the display unit periodically in weighing operation.
• The adjustment weight to be used depends on the capacity of the
weighing system. Carry out adjustment as near as possible to the
weighing system's maximum weight. Info about test weights can be
found on the Internet at: http://www.kern-sohn.com.
•
Observe stable environmental conditions. Stabilisation requires a certain
warm-up time.
Press
and
mode. [ECF 1] is displayed.
(The adjustment process can be exited at any time with
weighing mode.)
Confirm display of [ECF 1] with
displayed.
Acknowledge with
be displayed briefly. Then the display to input the
recommended adjustment weight is displayed (see chap. 1
"Technical data")
The left digit flashes.
Enter the value of the adjustment weight as follows:
Switch to the next digit to the right with
Increase number with
Confirm the value entered with
BIC-BA-e-1610
at the same time in weighing
. [CAL Z] is
. [--------] followed by [LOAd
.
.
.
. The balance returns then to
i
] will
(example)
11
Publicité
